Microblog


Posted on December 31, 2023

Got the door’s diagonal brace screwed to the frame with metal straps, and glued to the face. Weighing down the brace with bags of sand and gravel while the glue dries. Now we wait… #ProjectWineCellar #wine #woodworkingA homemade door frame built with 2x4 lumber, laying one a makeshift bench made of plywood. The door frame has a diagonal brace made of a 1x4. On the brace sits three bags of sand and gravel.

Read More


Posted on December 30, 2023

Today I cut, beveled, and tapered all the framing lumber for the door. Then I screwed together the rough frame and glued and nailed the outside skin. Tomorrow I fill the cavity with bracing and insulation. #ProjectWineCellar #wine #woodworking

Read More


Posted on December 30, 2023

To get the door to R-21 will take (3° 1°)/2 inches of foam insulation. That plus skin and trim will bring the total thickness to 5 inches. Which means the latch side needs to be sharply beveled in order to clear the jamb. So the outside will be a half inch wider than the inside. #ProjectWineCellar #wine #woodworking

Read More


Posted on December 30, 2023

We’ve finally reached the part of #ProjectWineCellar that I’ve been dreading: the door. The problem is that standard doors are only insulated to like R-3. This door needs to be R-21. So that means a custom door. I’ve never even hung a door, much less built a door. Thus my trepidation. #wine #woodworking

Read More


Posted on December 1, 2023

IND✈️MSP✈️PDX?McMinnville?

Read More


Posted on November 25, 2023

The family all headed home after Thanksgiving, so I took a little time to clean up the cellar threshold. I trimmed the plugs hiding the cement screws, sanded them smooth, and applied a first coat of Tung oil. Second coat tomorrow. #wine #woodworking #ProjectWineCellar

An oak door threshold surrounded by drop cloths.

Read More


Posted on November 15, 2023

Today was the last work day of this trip. I drilled pilot holes in the floor for concrete screws, and drilled counterbore holes in the threshold so that screw heads are hidden. Then I secured the threshold to the floor with concrete screws and a healthy helping of construction adhesive. Finally, I inserted oak dowels in the counterbore holes and glued them in place to hide the screw heads. Next trip I’ll cut the dowels flush to the surface and sand smooth. #woodworking #wine #ProjectWineCellar

Read More


Posted on November 14, 2023

Built a threshold for the cellar door today. Started with an oak 1×10, then I ripped to width, cut to length, notched the corners (for door trim), beveled the top edges, and cut rabbets to accommodate flooring. Hopefully I’ll be able to sand and install it tomorrow. #wine #ProjectWineCellar #woodworking

An oak board clamped to a woodworking bench. Painter’s tape covers the corners and midline where measurements are marked.End view of the work-in-progress threshold showing the top bevels.End view of the finished threshold with a plank of flooring slid into the rabbets that were cut into the bottom of the threshold.

Read More